BJM SKX1500CSSF, 201655, 2HP, 230V, 1 Phase, High Temperature/High Endurance 316 Stainless Steel Shredder Pump

Description

Summary: 316 Cast Stainless Steel Pumps with Shredder Action Impellers for Municipal, Industrial and Agricultural Waste-Water. Side discharge and non-clog single vane or double vane impellers for the passing of solids while delivering high volume of liquids. The Shredder (SKXF) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a “spiral” shaped diffuser plate. All wear and “wet” parts such as impeller, wear-plate, oil housing, pump-housing and inner pump top are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of FMK.

• All parts exposed to pumped liquids are made of 316 Stainless Steel.
• Elastomers are made of FMK.
• Longer Power Cord – Standard 33ft. power cord.
• Three Seal Motor Protection – Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150C), superior to pumps with Class A and B insulation.
• Complete with Control Box – All Single Phase Fahrenheit Pumps are supplied with NEMA 4X control box – including start components.

Each pump is tested at factory, both for performance as well as safety. Level controls and level control systems are available. Details: