BJM R15, 201384, 2HP, 460V, Cast Iron, Utility Service Pump
$2,730.00
2 HP, 460 V, 3-phase
Description
Summary:
“The Bullet” pumps are ideal for dewatering constructions sites, mines, or for all around use in industrial plants and utilities.
- Top Discharge – allows for superior cooling of motor and provides a slim line design.
- Longer Power Cord – Standard 33ft. power cord on pumps ½ HP and below and 50ft. on pumps 1HP and above.
- 304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
- Three Seal Motor Protection – Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic*. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
- More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
- Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components*.
- R400D Special Feature – “The Mop Up Pump”, will pump down to 1/12th of an inch. It features a special diaphragm value that prevents water backflow.
The Silver Bullet®and Mop-Up® are both registered trademarks of BJM Pumps, LLC. The Bullet™ is a trademark of BJM Pumps, LLC.
* Exception: R400D impeller made of fiberglass reinforced Noryl. Lower seal carbon/ceramic.
Details:
MAX. FLOW: GPM | 116 |
---|---|
MAX. HEAD: ft | 71′ |
PUMP TYPE | Top Discharge, Dewatering |
STRAINER OPENING | 0.25″ |
DISCHARGE SIZE | 2″ NPT-M |
MAX. SUBMERGED DEPTH | 65′ |
SHIPPING WEIGHT:lbs | 68 |
MOTOR CASING | 304SS |
---|---|
PUMP VOLUTE | Cast Iron |
IMPELLER – MULTI VANE | Cast Iron |
LIP SEALS & O-RINGS | Buna-N |
ROTOR SHAFT | 304 SS |
EXTERNAL HARDWARE | 304 SS |
QTY. OIL IN SEAL CHAMBER | 3.7 U.S. FL. OZ. |
MOTOR RATING: HP | 2 |
---|---|
MOTOR RPM | 3450 |
MOTOR INSULATION CLASS | F |
MOTOR SERVICE FACTOR | 1.1 |
VOLTAGE | 460, 3PH-60Hz |
CURRENT F.L.A. | 3 |
MOTOR PROTECTION | Thermal & Amp Overload |
POWER CORD: GAGE; LENGTH | A.W.G. 16/4; 50′, STOW |
MAXIMUM LIQUID TEMPERATURE | 104° F |
Seal Minder® | Not Available |
Additional information
Weight | 70 lbs |
---|